Are tensioner pulley reverse thread?

The PULLEY bolt on the tensioner is left hand thread (turn clockwise to loosen) but the bolt that retains the tensioner to the alternator bracket is standard right hand thread (turn counter-clockwise to loosen). If you are trying to remove the tensioner from the bracket it just takes a little muscle.

How do you release the tension on a serpentine belt?

Check for smooth rotation with a serpentine belt tool

-drive opening. Or use a socket on the hex-shaped protruding nut. Slowly rotate the tensioner arm as far as it will turn. Then release the tension.

How do you undo a tensioner?

How do you remove a tensioner pulley bolt?

How do you align a tensioner pulley?

The accessory belt needs to be loosened before the adjustment bolt can be turned on the side, top or bottom of the pulley. Turn the adjustment bolt clockwise to tighten the pulley.

Is the tensioner pulley supposed to move?

The tensioner arm should move smoothly and freely. Solution: If you notice a binding, sticking or grinding tensioner arm, the tensioner should be replaced.

How do you use a tensioner tool?

Is idler pulley same as tensioner?

The primary distinction between tensioners and idler pulleys is the presence of an adjustable bolt. Tensioners are positioned on the bolt through mounting. Idler pulleys are not mounted to an adjustable bolt. … However, if bearings fail, tensioner and idler pulleys both require replacement.

How tight should a tensioner pulley be?

When twisted either way from the middle, the tension in the belt must not be more than 12 inch. The belt is too tight if it is twisted more. The positions do not work for the vehicle.

Why is my belt tensioner moving?

Should tensioner be replaced with serpentine belt?

Tensioners add pressure from an adjustable pivot point or spring mechanism to keep your serpentine belt taut as it circulates around the engine. There is no recommended timeframe in which to replace your tensioner, especially as the belt itself usually needs replacing before the tensioner does.

Can you over tighten an alternator belt?

Dear Anthony: A belt should never be over-tightened. … An over-tightened belt can burn out any bearing that the belt rotates on, including alternator, power steering pump, A/C compressor, idler pulleys, etc. An over-tightened timing belt can ruin any pulley bearing it is connected with.

How do you fix a loose tensioner pulley?

Turn the adjustment bolt on the side, top or bottom of the pulley counterclockwise with the ratchet and socket until the accessory belt is loose enough to remove. Tighten the tensioner pulley by turning the adjustment bolt clockwise with the ratchet and socket until the belt is tight.

How tight should alternator bolts be?

Make sure the bolts are snug enough to hold the alternator in place, but loose enough to slide side to side in the bracket.

How do I loosen my alternator belt?

How to Loosen an Alternator Belt
  1. Open and secure your car’s hood. …
  2. Locate the alternator. …
  3. Look for the three bolts that secure the alternator. …
  4. Loosen the front and rear bolts attached to the alternator and engine using a suitably sized wrench. …
  5. Loosen the bolt attached to the adjustable bracket. …
  6. Remove the wrenches.